Touch RGB LED stripes RF set controller, 12/24 v, 1-zone
|
|
||||||||||||||
|
299,- Kč with VAT |
|||||||||||||||
Item description:
The touch remote control set allows you to comfortably control
12V and 24V RGB LED stripes.
Using the wireless touch RF controller, you can control the diodes freely, change brightness, individual colors, dim and smoothly light up. Buttons for brightness, speed and preset mode selection. Plug and play connection.
Remote control range up to 30 m. RF transmission, no direct visibility between controller and receiver is required. Memory effect - the LED strip turns on in the last selected mode or color.
White color = press "ON" button for a 3 sec.
Simply attach the strap with screw-in terminal blocks. Possibility to attach the controller using a self-adhesive plate.
Pairing the receiver and remote control:
- insert 2x AAA batteries into the remote control, paying attention to the correct polarity.
- connect the LED strip to the terminal blocks in the receiver (V + = ground, other terminals for individual strip colors)
- connect the receiver to a 12 V - 24 V DC power supply
- Disconnect the power supply and receiver.
- restore power and within 6 seconds synchronously press the two upper buttons (- O)
and hold these for more than 2 seconds.
- if the LED strip flashes and responds to commands from the controller, then the pairing has been performed successfully.
- if the LED strip does not flash, repeat the previous steps.
We also offer the same set for RGBW LED stripes control.
Technical specifications
Voltage: DC 12 V~24 V
Control: RGB 3 channels
Frequency: 2,4 GHz
Transmission: RF (radio frequency)
Maximum load per 1 channel: 6 A
Total output load: 18 A
Output wiring: common anode
Control range: up to 30 m
Dimensions: 85 x 45 x 23 mm
RF Remote Control Power Supply: 2x LR03 1.5V AAA Battery
(including)
